D-Link Support Publishing       IBMLAN.TXT                       Feb. 1996

     D-Link DE-650CT PCMCIA Ethernet Card Installation for IBM Lan Support
                              and Lan Services

 Contents
 
        Introduction
        Requirements
        Minimum Skill Level
        Compatibility List
        Getting Started

 Introduction
 
        This installation assumes that the PCMCIA drivers are working properly.
        Please consult INST_DOS.TXT for help with PCMCIA Drivers.
        Getting Started will describe the installation for Lan Support/Servers.

 Requirements
 
        A PCMCIA compatible Laptop
        A PCMCIA chipset that is PCIC compatible (Intel, Cirrus, Vadem, and
         VLSI) or Databook compatible.
        IBM Lan Support 2.0/higher or Lan Services 4.x
        A DE-650CT (our single media cards are not supported, 650T and 650C)
        A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
        A knowledge of basic DOS commands
        A knowledge of editing text files
        A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
        A knowledge of the network driver configuration being used
        Please see Support Options if you are not comfortable will this
         skill level

 Compatibility List
 
        DE-650CT only (will not run with DE-650T or DE-650C)
        Removal of any present PCMCIA drivers
        For a laptop compatibility list please consult your local
         D-Link Branch Office

 Getting Started
 
        Installation for IBM Lan Support 2.x (see below for Lan Services 4.x)
        Please use Method 1 or 2 for this installation

        Method 1 -- Using the .NIF file:
        Insert the LAN Support diskette in Drive A.
        Run the install program.

                 A:\> DXMAID [Enter]

        The following message then appears:

                 "Do you have driver diskettes?"  [Yes]

        Use the Spacebar to switch between "no" and "yes".

        After copying LAN Support, specify the drive and path of the
         DOS NDIS files.

         For example: C:\LSP [Enter]

        The installation procedure terminates after copying the
         necessary file.

        Method 2 -- Modifying the contents of the CONFIG.SYS and
         PROTOCOL.INI files after installing other NICs:

        Copy the DE65S.DOS file to the directory where your IBM LAN
         Support program resides.

        Modify the NDIS device driver statement in the CONFIG.SYS
         as follows:

          DEVICE = [drive]:\path\DE65S.DOS

        Modify the PROTOCOL.INI file as follows:

           BINDINGS = DE65SIBM_NIF
                     :
                     :
          [DE65SIBM_NIF]
          DRIVERNAME = DE65S$

     IBM LAN Services v4.x installation instructions

        Execute the installation program from the IBM DOS LAN SERVICES diskette

                Type: >a:\install

        From the Network card field, select "Network card not shown in list
         below...".

        Specify the path for the corresponding oemsetup.inf file of the OEM
         driver intended for use.  Then, press Enter. The program then displays
         the driver name.

        Check that the driver configuration is correct.

        Complete the installation, restart your system to use the DOS LAN
         Services.

