D-Link Support Publishing       DLKTCP.TXT                       Feb. 1996

                D-Link DE-650CT PCMCIA Ethernet Card Packet Driver
                         Installation for D-Link's TCP/IP

 Contents
 
        Introduction
        Requirements
        Minimum Skill Level
        Compatibility List
        Getting Started

 Introduction
 
        This installation assumes that the PCMCIA drivers are working properly.
        Please consult INST_DOS.TXT for help with PCMCIA Drivers.
        Getting Started will describe the installation instructions.

 Requirements
 
        A PCMCIA compatible Laptop
        A PCMCIA chipset that is PCIC compatible (Intel, Cirrus, Vadem, and
         VLSI) or Databook compatible.
        D-Link's TCPIP for DOS
        A DE-650CT (our single media cards are not supported, 650T and 650C)
        A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
        A knowledge of basic DOS commands
        A knowledge of editing text files
        A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
        A knowledge of the network driver configuration being used
        Please see Support Options if you are not comfortable will this
         skill level

 Compatibility List
 
        DE-650CT only (will not run with DE-650T or DE-650C)
        Removal of any present PCMCIA drivers
        For a laptop compatibility list please consult your local
         D-Link Branch Office

 Getting Started
 
        There are two methods of running the D-Link's TCP/IP program.

        METHOD 1:
       
        If the DE65SPD.SYS program is used, the following statement
                must be included in your CONFIG.SYS file:

        DEVICE = DE65SPD.SYS [/d] [/w] <packet_int_no>

                <packet_int_no> is the software interrupt vector number used by
                                the packet driver program.  This can be from 96
                                to 128.
                /d              Delay Initial - The driver program will not
                                initialize the network interface card until the
                                packet driver program is accessed by its upper
                                layer program.

                /w              The -w parameter is for use only in the Windows
                                environment.

                See INST_DOS.TXT for addition parameters

            You can place this line anywhere in the CONFIG.SYS file.

        METHOD 2:
        
        If the DE65SPD.COM program is used, follow these steps:

        Modify your AUTOEXEC.BAT file to include the following line:

         set HOSTS=<PATH>

        <PATH> here is the directory where the D-Link TCP/IP
        programs reside.

        Execute DE65SPD.COM by typing the following:

        >DE65SPD [/option] <packet_int_no>

        Execute TCPSTART.EXE to start TCP/IP.

